CKD紧固型气缸结构原理，喜开理紧固型气缸作用
请**带防坠功能的气缸。另外，也请**前端附带还是后端附带。（用略图示出）
注2：请**带防回转功能的气缸。
Note 9: Only the front-end anti-fall type can be made.
Note 10: G2, G3 and P7, P71 case, the piston rod,
nut material has been stainless steel (M). (Do not need M symbol.)
Note 11: In the case of anti-rotation, the material of the piston rod is stainless steel.
(In the case of M, the piston rod nut is made of stainless steel.)
Note 12: For the new precision P7, P71, refer to "Clean Room Element System" (Sample No.CB-O33S).
注5：行程末端的缓冲区域不能满足低速**。
注6：可对应100摄氏度以下的使用温度。
注7：有时可能会因防尘套的反作用力而不能满足低速**。
注8：必须确认飞出到气缸上的溶剂或者切削液与防尘套之间的相容性。
Note 6: can be used at temperatures below 100 degrees Celsius.
Note 7: It may not be possible to meet low-speed performance due to the reaction force of the dust cover.
Note 8: It is necessary to confirm the compatibility of the solvent or
cutting fluid that is flying out of the cylinder with the dust cover.
注3：不带防坠功能的端盖侧带有缓冲。（比如，CMK2-Q-32-H时，前端带有缓冲。）
注4：摩擦阻抗*于标准的低速型（或者微速型）。
Please specify the cylinder with anti-fall function. In addition,
please specify whether the front-end or back-end is included. (Shown in thumbnail)
Note 2: Please specify the cylinder with anti-rotation function.
Note 3: The end cover side without the anti-fall function is provided with a cushion.
(For example, CMK2-Q-32-H, the front end with a buffer.)
注9：仅可对应前端防坠型。
注10：G2，G3及P7，P71的情况下，活塞杆、螺母的材质已为不锈钢（M）。（不需要M符号。）

CKD紧固型气缸结构原理，喜开理紧固型气缸作用