油研进口日本电磁开关阀技术参数
上海乾拓贸易有限公司
企业QQ：
电话；021-69001039
手机；17321017802（微信）
邮箱；17321017802@163.com
地址：上海市嘉定区江桥嘉涌路99弄6号楼713室
 Internal leakage are very small, less than 5 drips per min., which is achieved by the poppet design.
 Two mounting types:  cartridge and subplate Mounting dimensions for both types conform to ISO standard.
 Water-proof type (conforming to JIS D 0203 Water Spray Test 32) is also available.
不要将端口“1”连接到经受浪涌压力的线路上。
另外，如果使用“1”端口作为油箱管路，
 Oil temperatures between -15/+70°C (5 - 158°F).
 Use hydraulic fluids which satisfy the recommended viscosity and oil temperatures given above.
用于满足这一时代的需求，如能源和资源节约。
墨盒类型/子板安装电磁阀操作方向阀DSPC / DSPG-01/03（1/8，3/8）
Do not connect port "1" to a line subjected to surge pressures. 
In addition, if you use port "1" for tank line, be sure to keep the end of the line in the oil.
Protections against dust and water conform to the international electric standard (IEC) PUBL 529 IP64.
可以使用表中列出的任何类型的液压油。 **的粘度和油温
必须注意保持对液压油污染的控制，否则可能会导致故障并缩短阀门的使用寿命。
Maximum Flow Rate The zone under each shaded line denotes the flow rate ranges being free of trouble in changeover. 
 Typical Performance Characteristics at Viscosity 30 mm /s (141 SSU) [ISO VG 46 oils, 50°C(122 °F)]
Maximum flow rates depend on operating conditions.
关闭式电磁式方向阀是提供型电磁式双向方向阀，
Cartridge Type / Sub-plate Mounting SOLENOID OPERATED DIRECTIONAL VALVES DSPC/DSPG-01/03(1/8, 3/8)
High-response
 请保持NAS 1638-Grade 12内的污染程度。使用25μm或更细的线路滤波器。 控制污染
2粘度介于15 - 400 mm / s（77 - 1800 SSU）之间。
油温在-15 / + 70°C（5 - 158°F）之间。
 使用满足上述给出的**粘度和油温的液压油。
*响应
流量取决于操作条件。
Please maintain the degree of contamination within NAS 1638-Grade 12.  Use 25 μm or finer line filter.  Control of Contamination
2  Viscosity ranging between 15 - 400 mm /s (77 - 1800 SSU).
Due caution must be paid to maintaining control over contamination of the hydraulic fluids
which may o therwise lead to breakdowns and shorten the life of the valves.
High response is provided by the poppet design. Smallest internal leakage
提升阀设计提供了很*的响应。 小的内部泄漏
内部泄漏非常小，每分钟小于5滴，这是通过提升阀设计实现的。
两种安装类型：墨盒和底板两种类型的安装尺寸符合ISO标准。
防水型（符合JIS D 0203 Water Spray Test 32）也是可以使用的。
The shut-off type solenoid operated directional valves are poppet type solenoid operated two-way directional valves
developed to meet the needs of this age such as energy and resources saving.
请确保将油管的末端保持在油中。
防尘防水符合国际电气标准（IEC）PUBL 529 IP64。
流量每个阴影线下的区域表示流量范围无切换的麻烦。2
典型**特性粘度30 mm / s（141 SSU）[ISO VG 46油，50°C（122°F）]
Any type of hydraulic fluids listed in the table below can be used.
 Recommended Viscosity and Oil Temperatures

油研进口日本电磁开关阀技术参数